Guide Sleeve - Without Cleat - With Lip - 3.9 mm x 5 mm Drills Sleeve is used to make

Sleeve is used to make a Guide for full edentulous implant cases

Bending Plate Protractor

0 mm x 30 mm L

035” Hex Driver is used to tighten and loosen the Stylus Set Screw against one of the four flat sides of the Guide Post

Place the Fabrication Insert inside the Guide Sleeve over the corresponding Guide Post and then apply gel

Guide Sleeve - Without Cleat - With Lip - 3.9 mm x 5 mm Drills Sleeve is used to makeThe 3. 9 mm Guide Sleeve Without Cleat With Lip is for use with printed guides only. Sleeves are designed with a lip which secures the stereolithographic printed Guide Sleeve so it will not slip through the printed guide hole. Dimensions: ID 3. 9 mm x OD 5 mm x 5. 07 mm L OD 6. 2 mm lip x . 05 mm lip thickness Pair with: 3. 9 mm Depth Stop Drill Set